Same day courier dispatch*
Fast delivery up to 5 working days
Extensive range and stock holding

Roll Top Ridge Cap, Galvanised, 150mm x 150mm x 120°

Item
SF1RTGV
As low as £17.52 £14.60
Only %1 left
payment-logos

Technical Specifications

  • Dimensions - 150mm x 150mm
  • Angle - 120deg
  • Finish - Plain Galvanised
  • Material - Galvanised Steel
  • Thickness - 0.7mm
  • Weight - 4kg
  • Lap - 100mm mimimum
  • Edges - Welted

The ridge flashing is to be used on apex buildings to cover the void where the sheets meet at the ridge of the building. These ridges are in a plain galvanised finish in a 0.7mm gauge. These used to be used with old asbestos roofs but are now more commonly used with 3" galvanised corrugated sheeting.

  • 150mm wide wings
  • Plain Galvanised
  • Allow a minimum of 100mm for overlapping
  • Ideal suited for use with Corrugated Galvanised steel sheets or with Onduline sheeting
  • Lightweight & easy to handle
  • Easy to install
  • Roll at the ridge to make aesthetically pleasing
  • Colour matched to sheets
  • Welted for extra rigidity  

How much should I lap the ridges over one another?
You should have a minimum of 150mm for lapping the ridges.

Do I just fix it down with the top run of main fixings?
No, you want to use the stitchers screws to stitch the ridge to the highest point of the profile on the sheet.

How do I know what angle ridge cap I need?
To work out the ridge angle, you will need to work out the angle of each slope (commonly the same each side on apex buildings). You then minus the two angles from 180° degrees to give you the angle of ridge you need. E.g. if you have an equal apex roof with 30° it would be 180° - (30° + 30°) = 120°.

Is there any flexibility in the ridge flashing?
There is a small amount of flexibility in the ridge, so if you are using our 120° stock ridge you will be able to flex it some degrees either way.

Can I get different sized flashings?
Yes, we can manufacture made to order flashings. If you want to make an enquiry, please contact our sales team.

Can Southern Sheeting cut flashings?
Southern Sheeting will not cut stock flashings. Made to order flashings can be cut to different lengths and girths.

Customer Questions
No Customer Questions
Did you find what you were looking for?
Write Your Own Review
You're reviewing:Roll Top Ridge Cap, Galvanised, 150mm x 150mm x 120°
Your Rating

Find the right materials and support for your project

We can help! View our supportive help guides and videos.

Our supportive guides and help videos will help you achieve the best results. Our knowledgeable team can also offer helpful tips, and support to help you plan and purchase what you need!